Views: 17 Author: Site Editor Publish Time: 29-06-2020 Origin: Site
The so-called "thin paving" is relative to the traditional tile paving, the thin paving process was first created in Germany. Required tools: tile adhesive and toothed scraper. The tile adhesive is combed into stripes at the base of the construction. The dry work pasting method of kneading, squeezing, compacting, and positioning is adopted. The construction process is very fast and firm.
There are three main methods of thin paving:
1. Base coating method
Spread an appropriate amount of adhesive glue on the bottom of the construction, and use a spatula with a suitable pitch to make it 60-70 degrees, comb it into a full zigzag strip along a straight line, and press the ceramic tile or stone against the adhesive On the base layer, to ensure that the entire paste is adjusted to the appropriate position as required. Use a serrated spatula to scrape the cement mortar that has just been wiped out into a zigzag shape, and use a laser level to do the positioning. Then you can paste the tiles one by one.
2. Back coating method
To remove dust and debris on the back of the tile, first apply a small amount of adhesive glue and scrape the back of the tile with a spatula. Then apply an appropriate amount (3-10mm) of adhesive mortar on the back of the brick again, scrape out the stripes with a serrated knife, and paste the adhesive mortar tile on the wall as required.
3.The strongest combination method
For large-size tiles, please use this method to apply an appropriate amount of adhesive to the construction wall, and use a spatula with a suitable pitch to make a full strip texture along a straight line at 60-70 degrees. Scrape a small amount of adhesive glue on the back of the tile, smooth the groove on the back, and paste the ceramic tile with glue to the right position as required.
Do not move the tile after 15 minutes after being attached. If you need to adjust it, you must quickly remove the adhesive on the back of the tile and the construction surface, and then paste it again with adhesive glue.
Do not add water or dry binder powder.
