YIDA-HPMC Cellulose Manufacturer


Name   Hydroxyethyl cellulose

Model  SK300

 Product Description

Yida Hydroxyethyl Cellulose (HEC) SK300 is a product specially developed by Yida scientific research team for texture paint and latex paint. The product has good thickening and suspension effect, high water retention rate, small addition amount, and low product unit price to reduce production costs. 


Scope Of Application

SK300 is widely used in the production of internal and external wall latex paint and texture paint, which has a good thickening and suspension effect.


System category 

Test dosage /‰

Status description 

Interior wall latex paint


Good thickening effect, no layering

Exterior wall latex paint


Good thickening effect, no layering

Texture paint


Good spraying, less sand falling






White or light yellow powder 


98% pass 80 mesh

Water content/%


PH value


Viscosity (2%, 20℃)  



Add Way

(1) Pre-dissolve in other containers beforehand, weigh the water in the specific steps, stir with an electric drill, and slowly add hydroxyethyl cellulose until it is completely dissolved. Pour the pre-dissolved cellulose solution directly into it during the formal production process

(2) Directly and slowly sprinkle hydroxyethyl cellulose in the production process to completely dissolve

(3) Half of it is pre-melted, and half is sprinkled in the production process Regardless of whether the pre-solution is made or the hydroxyethyl cellulose is directly sprinkled in the production process, it should not be poured all at once. Only use utensils or hands to slowly sprinkle, try to avoid cellulose clumping In the production process, do not add multifunctional additives before adding hydroxyethyl cellulose, otherwise the cellulose is easy to clump and lumpy



During the production process, the equipment must be turned on when the hydroxyethyl cellulose is sprinkled, and the cellulose can be sprinkled slowly after the equipment is rotated. Viscosity change: a momentary high-viscosity state and a rough state. After a few minutes of continued stirring, the viscosity will stabilize and the state will improve significantly. If you simply test the viscosity of the aqueous solution of cellulose, you can complete the aqueous solution on the first day, test the viscosity on the second day, and observe the state. Because there are many bubbles in the freshly prepared aqueous solution, the transparency and viscosity test indicators are not accurate due to their influence


Recommended Dosage

The recommended dosage of this product is 2-4‰ of the system, and the dosage needs to be determined by experiment


Packaging And Storage

After the product is opened and used, it must be sealed in time; This product is thermoplastic, so it should be stored in a high temperature environment to avoid pressure, otherwise it will easily cause agglomeration; Sealed and stored in a cool and dry place at 0-40℃, and the storage time should not exceed 24 months.


Technical Support

During the preparation of various formula systems for this product, the Yida technical team can provide technical consultation, technical tracking, and long-term optimization of the formula system.

Contact Us and Get Free Samples